Question
a.
True
b.
False
c.
May be True or False
d.
Can't say
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a circular waveguide TE₂₁ mode has lowest cutoff frequency
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The number of TV channels which can be accommodated in a spectrum of 300 MHz is about
View solution
Q. The noise figure of multicavity klystron amplifier is very low
View solution
Q. Assertion (A): The velocity of electromagnetic waves on overhead lines and coaxial cables is the same.
Reason (R): Free space has an intrinsic impedance of 377 ohms.
View solution
Q. A cavity resonator is
View solution
Q. If antenna diameter is increased four times, the maximum range is increased by a factor of
View solution
Q. Assertion (A): Gunn diode is a transferred electron device.
Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.
View solution
Q. Atomic and molecular resonance is observed in many substances
View solution
Q. A reflex klystron oscillator is a
View solution
Q. Consider the following applications:
1. TV tuning
2. Active filter
3. Microwave frequency multiplication
In which of above can a varactor diode be used?
View solution
Q. Consider the following statements:
1. Dissipative attenuator has a fixed value of attenuation.
2. Reflective attenuator has a fixed value of attenuation.
3. Both dissipative and reflective attenuators are available only with fixed attenuation.
4. Both dissipative and reflective attenuators are available with either fixed or variable attenuation.
Which of the above are correct?
View solution
Q. Impedance inversion may be obtained with
View solution
Q. Power gain of a multicavity klystron amplifier is
View solution
Q. The expression HZ = C cos(Bx) cos(Ay)yz is for
View solution
Q. Assertion (A): Impedance matching can be done by using stubs.
Reason (R): A double stub is used for impedance matching when frequency of signal varies.
View solution
Q. Read the following statements about TWT
1. It uses thermionic emission.
2. It uses an attenuater.
3. It is inherently a resonant device.
4. It has broad bandwidth.
Which of the above are correct?
View solution
Q. If a line having Z₀ = 300 ∠ 0 W is short circuited at far end, VSWR is
View solution
Q. A klystron amplifier generally uses Pierce gun
View solution
Q. If a short line is terminated in characteristic impedance it behaves as an infinite line.
View solution
Q. Ga As exhibits negative differential mobility
View solution
Q. Consider the following statements:
1. Bunching of electrons occurs in two cavity klystron amplifier.
2. Bunching of electrons occurs in multi cavity klystron amplifier.
3. Bunching of electrons occurs in reflex cavity klystron amplifier.
Which of the above statements are correct?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!