Question

The inductance of a twin feeder used to connect antenna to TV receiver is about

a.

0.2 μ H/m

b.

0.6 μ H/m

c.

1.6 μ H/m

d.

10 μ H/m

Answer: (c).1.6 μ H/m

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The inductance of a twin feeder used to connect antenna to TV receiver is about

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Assertion (A): Impatt diode is an avalanche diode.

Reason (R): Avalanche breakdown phenomenon occurs when a p-n junction is reverse biased.

Q. A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is

Q. In a line with finite attenuation

Q. The electric field in a TWT due to applied signal

Q. A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is

Q. The word 'LORAN' means

Q. The duty cycle of a radar transmitter is equal to

Q. In a klystron amplifier the bunching effect

Q. Which of the following modes of transmission will not be supported by a rectangular waveguide?

Q. In a circular waveguide with radius r, the dominant mode is

Q. If 'a' is the width of rectangular wave guide and 'λ' is the wave length, then

Q. A parametric amplifier uses

Q. Assertion (A): Impatt diode can be used in both amplifiers and oscillators.

Reason (R): Impatt diode has a low resistance.

Q. Which one of the following can be used for amplification of microwave energy?

Q. At frequencies of 10 MHz and higher the impedance represented by ground is primarity

Q. A disadvantage of microstrip line as the connections of compared to strip line is that former

Q. As frequency increases, the transmission efficiency

Q. A circular polarizer converts a linearly polarized wave into a circularly polarised wave.

Q. If D is diameter of circular waveguide the cutoff wave-length for TE₁₁ mode is equal to

Q. The external magnetic field in a magnetron is such that lines are

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!