Q. A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is

View solution

Q. A line of length slightly longer than λ/4 and open circuited at far end behaves as

View solution

Q. Klystron amplifier is not used to amplifier very weak microwave signals due to

View solution

Q. Which of the following modes in circular waveguides are circularly symmetric?

View solution

Q. Which of the following lines behaves as infinite line?

View solution

Q. A rectangular waveguide has two stubs each length λ/4 connected at the source end. The stubs are short circuted. Then

View solution

Q. Performance of a PIN diode switch is represented by

View solution

Q. As frequency is increased, the skin effect

View solution

Q. In a rectangular waveguide there is one half wave variation of electric field across the narrow dimension and two half wave variations of electric field across wider dimension. The dominant mode is

View solution

Q. VTM stands for voltage tunable magnetron.

View solution

Q. Which of the following is used in integrated circuits?

View solution

Q. The π mode of operation of magnetron signifies that

View solution

Q. Consider the following statements (L is the length of array between centres of end antennas and A is wave-length)

1. Width of major lobe between nulls of broad side array and end fire array are different.
2. Directive gain of broadside array and end fire array are different.
3. Directive gain of broadside array is 4(L/λ) .

Which of the above statements are correct?

View solution

Q. The electrical requirement on wall thickness of rectangular wave guide is

View solution

Q. If a microstrip is enclosed in a metal enclosure

View solution

Q. Which of the following is a balanced line?

View solution

Q. A line of characteristic impedance 400 Ω is terminated by a resistance of 400 Ω. The reflected quantities are

View solution

Q. A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to

View solution

Q. Wave guides are pressurised above normal atmospheric pressure for

View solution

Q. Assertion (A): In a power divider SH = 0, S21 = 0.707 = S3.

Reason (R): In a power divider the input port (i.e., port 1) is matched and incident power is equally divided in output ports 2 and 3

View solution