Question

When a wave reaches an open circuit

a.

the voltage at termination is doubled the incident voltage

b.

the current at termination is doubled the incident voltage

c.

the voltage at termination is zero

d.

both V and I at termination are doubled the incident voltage and current

Answer: (a).the voltage at termination is doubled the incident voltage

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. When a wave reaches an open circuit

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Assertion (A): In circular waveguide the attenuation of TE01 mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TEQ1 mode are completely circumferential.

Q. Consider the following statements

1. Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
2. For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
3. Ridge wave guide has higher conductor losser than a rectangular waveguide.
4. Ridge guide has higher conductor losser than a rectangular waveguide.

Which of the above statements are correct?

Q. Directive gain of elementary doublet is

Q. A directional coupler is used

Q. Assertion (A): In rectangular waveguide TE₀₁ mode is just TE₁₀ mode rotated by 90°.

Reason (R): When a rectangular waveguide is rotated by 90°, the broad and narrow dimensions get interchanged.

Q. Consider the following statements about a magic tee

1. The collinear arms are isolated from each other.
2. On of the collinear arms is isolated from E arm.
3. On of the collinear arms is isolated from H arm.
4. E and H arms are isolated from each other.

Of the above statements

Q. Assertion (A): Hollow waveguides are frequently used as transmission lines at microwave frequencies.

Reason (R): Waveguide has high power handling capacity, low loss and simple structure.

Q. In π mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to

Q. In rectangular waveguides the ratio of width to height is about

Q. Which of these statements is correct?

Q. A rectangular waveguide has width a. Then at the cutoff frequency (with corresponding wave length λc)

Q. Ridge waveguide is essentially a form of capacitively loaded guide.

Q. In a rectangular waveguide

Q. Which of the following modes cannot exist in rectangular resonant cavity?

Q. In a Gunn diode oscillator drift velocity of electron is 10⁷ cm/s and active region length is 10 x 10‾⁴ cm. The natural frequency of oscillation is

Q. Assertion (A): An artificial transmission line can be used as a pulse generator.

Reason (R): A pulse function is used very frequently in network analysis.

Q. Consider the following statements about hybrid ring

1. Ports 1 and 2 are decoupled.
2. Port 3 and 4 are coupled.
3. A signal entering either port 1 or 2 splits equally between ports 3 and 4.
4. A signal entering either port 3 or 4 splits equally between ports 1 and 2.

Which of the above are correct?

Q. TM₀₁ mode in circular waveguide is analogous to

Q. In microwave system, waveguide twists

Q. A 'rat race' is a

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!