Q. The following equation, corresponds to __________ analogy.

View solution

Q. Out of the following four assumptions used in the derivation of the equation for LMTD given by below equation, which one is subject to the largest deviation in practice ?

View solution

Q. For flow over a flat plate, the ratio of thermal boundary layer thickness, 'xt' and hydrodynamic boundary layer thickness 'x' is equal to (where, NPr = Prandtl number)

View solution

Q. The interchange factor for radiation heat transfer from surface 'x' to surface 'y' in case of an infinite parallel planes with emis-sivities εx & εy is given by

View solution

Q. What is Nusselt number ?

View solution

Q. The Dietus-Boelter equation for convective heat transfer given by following equation, cannot be used for

View solution

Q. The rate of heat transfer through a pipe wall is given by following equation. For cylinder of very thin wall, q can be approximated by

View solution

Q. Graetz number is given by

View solution

Q. Harmonic mean temperature difference is given by

View solution

Q. Thermal diffusivity is given by

View solution

Q. At steady state the temperature variation in a plane wall, made of two different solids I & II is shown below. The thermal conductivity of material I

View solution

Q. In case of surface condensers, a straight line is obtained on plotting 1/U vs __________ on an ordinary graph paper.

View solution

Q. Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)

View solution

Q. For a counter current heat exchanger with Tih = 80°C, T°c = 60°C, T°h = 50°C and Tic = 30°C, and the temperature difference between the two streams being the same everywhere along Z, the direction of flow of hot fluid. The temperature profile should satisfy

View solution

Q. Following number is called the __________ number.

View solution

Q. What is the logarithmic mean of r1 and r2 ?

View solution

Q. The following equation is the __________ analogy.

View solution

Q. The number given below is termed as the __________ number.

View solution

Q. Heat transfer co-efficient (h) for a fluid flowing inside a clean pipe is given by following equation. This is valid for the value of NRe equal to

View solution

Q. Prandtl number is given by

View solution