Q. The following equation is for

View solution

Q. The following equation is for

View solution

Q. The following plot gives the saturated humidity (He) versus temperature (T).Line joining (H1, T1) and (H2, T2) is the constant enthalpy line. Choose the correct one from among the alternatives A, B, C and D.

View solution

Q. Which of the following liquid temperature (T) Vs. vapor-gas mixture enthalpy (H) diagram is valid for humidification operation?

View solution

Q. Which of the following is not a unit of mass transfer co-efficient ?

View solution

Q. The surface renewal frequency in Danckwerts' model of mass transfer is given by (KL: mass transfer co-efficient)

View solution

Q. A distillation column separates 10000 kg/hr of a benzene-toluene mixture as shown in the figure below.
In the figure xF, xD and xW represent the weight fraction of benzene in the feed, distillate and residue respectively.

The reflux ratio is

View solution

Q. Which of the following is the correct ternery diagram for liquid-liquid extraction system comprising of two pairs partly soluble (e.g., chlorobenzene-water-methyl ethyl ketone system) ?

View solution

Q. If moisture content of solid on dry basis is X, then the same on wet basis is

View solution

Q. If xD = overhead product molal composition and RD = reflux ratio, then slope and intercept of the operating line for rectifying section are respectively

View solution

Q. Below is given an equilibrium moisture curve of a substance. State which regions represent free moisture and unbound moisture respectively.

View solution

Q. The following expression is

View solution

Q. Which of the following is the correct ternery diagram for liquid-liquid extraction system comprising of one pair partly soluble (e.g. water-benzene-acetic acid in which A-diluent, B - solvent and C - solute)?

View solution

Q. The velocity, concentration and temperature boundary, for the boundary layer development on a flat plate during connective mass transfer will be same, if

View solution

Q. For the gas absorption, the height of a transfer unit, based on the gas phase is given by (G: superficial molar gas velocity, L: superficial molar liquid velocity, FG:mass transfer co-efficient, mols/m² , a: in-terfacial area per unit volume of tower)

View solution

Q. Relative humidity is the ratio of the

View solution

Q. In batch distillation with constant reflux, overhead product composition __________ with time.

View solution

Q. Psychrometry deals with the properties of gas-vapor mixture. Humidity can be determined by the measurement of the __________ of a fibre.

View solution

Q. Heat in BTU necessary to increase the temperature of 1 lb of gas and its accompanying vapour by 1°F is called the

View solution

Q. To increase the absorption factor, (where, G = gas flow rate, S = solvent flow rate)

View solution