Question
a.
compared to the mass flow rate of cooling water, the rate of condensation of steam is invariably smaller.
b.
maintaining vacuum on tube side is more difficult than that on the shell side.
c.
water velocity can be increased conveniently to increase the overall heat transfer co-efficient because of its lower specific volume compared to steam.
d.
condenser can act as a storage unit for condensed steam.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In condensers used in thermal power plants, steam is normally used in shell side and cooling water on the tube side, because of the reason that
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Cobalt - 60 is used as a source of __________ in medical therapy & industrial radiography.
View solution
Q. Absolute zero pressure can be attained at a temperature of
View solution
Q. The product out from a cupola is called
View solution
Q. In troposphere (the weather domain), the temperature 't' at height 'h' above the sea level in metres is given by (where, temperature at sea level is 15°C and t is in °C.)
View solution
Q. A high pressure boiler generates steam at a pressure greater than __________ kg/cm² .
View solution
Q. Evaporative cooling process employs a combination of cooling and humidification in which the
View solution
Q. Which of the following is not an explosive ?
View solution
Q. Maxwell's thermodynamic relations applies to the
View solution
Q. Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect of free convection over a vertical flat plate as
View solution
Q. If the demand for an item is trebled and the order cost is reduced to one third, then the economic order quantity
View solution
Q. Copper deposits are found in India at the following location:
View solution
Q. Electrical conductivities of semi-conductors are of the order of __________ ohm/cm.
View solution
Q. Corrosion of metals can not be prevented by its
View solution
Q. The elastic strain energy of a unit length of an edge dislocation as compared to that of a screw dislocation is
View solution
Q. The specific gravity of coal depends mainly on its __________ content.
View solution
Q. In case of condensers & evaporators operating under given terminal conditions, LMTD (logarithmic mean temperature difference) for counter flow as compared to that for parallel flow is
View solution
Q. Normalising does not __________ of a metal.
View solution
Q. Which of the following hardness tests does not measure the indentation hardness of metals and alloys ?
View solution
Q. To counteract the bad effects of strain hardening on a cold formed part, it must be
View solution
Q. The dew point temperature lines on psychrometric charts are straight inclined sloping downwards to the right. When relative humidity of moist air is 100%, then
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
