Q. Primary designation of steel is based on its

View solution

Q. Steel containing low percentage of nickel, chromium & tungsten are termed as the __________ steel.

View solution

Q. Superheating of steam is done at constant

View solution

Q. Dry saturated steam can be converted into superheated steam by

View solution

Q. Pick out the wrong statement.

View solution

Q. Increasing sulphur content in pig iron tends to make it

View solution

Q. Oxyacetylene reducing flame is used while carrying out welding on

View solution

Q. M₁₀ index of coke indicates its

View solution

Q. Baffles provided on the shell side of a shell and tube heat exchanger are meant for

View solution

Q. When an isolated thermodynamic system executes a process,

View solution

Q. Brittleness induced due to the presence of sulphur in steel can be reduced by adding

View solution

Q. Atomic __________ of an element is a whole number.

View solution

Q. The boiling & freezing points on a newly defined temperature scale in degree 'D' are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to __________ °D.

View solution

Q. A cylinderical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is

View solution

Q. The surface tension of a liquid, at critical temperature is

View solution

Q. Large scale fire on fuel gas line is normally extinguished by

View solution

Q. Brazing is the joining of metals

View solution

Q. Moist climate is the most favourable factor in the site selection far a

View solution

Q. __________ iron is produced by the annealing of white cast iron.

View solution

Q. The mechanism which changes the value of manipulated variable in response to the output signal from the control unit is called the

View solution