Q. With decrease in the grain size of a material, its creep resistance

View solution

Q. __________ rubber is generally used for making 'O' rings used for vacuum sealings.

View solution

Q. Gas turbine normally employs a constant __________ cycle.

View solution

Q. Which of the following relationships is correct for relating the three elastic constants of an isotropic elastic material (where, E = Young's modulus, G = Modulus of rigidity or shear modulus v = Poisson's ratio) ?

View solution

Q. Electrostatic separation of minerals from each other is based on their differences in the following property.

View solution

Q. Natural water contains approximately __________ percent of heavy water.

View solution

Q. The minimum temperature to which the water can be cooled in a cooling tower is the __________ temperature of air.

View solution

Q. In electrical resistance welding, distortion results from the use of improper

View solution

Q. The conventional mechnical transducer, which converts pressure signal to displacement signal is

View solution

Q. Pick out the wrong statement.

View solution

Q. Austempering of steel requires.it to be heated to 875°C followed by sudden cooling to 250-525°C, thereby changing austenite to

View solution

Q. A compact estimate about the amount of materials handling between various work stations is obtained from the

View solution

Q. __________ can replace tungsten in high speed steel.

View solution

Q. Production of one ton of paper in Indian paper industry consumes about __________ kWh of electricity.

View solution

Q. Fatigue strength of a material can not be increased by

View solution

Q. Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal

View solution

Q. Out of the following the refractive index is the highest for

View solution

Q. Maximum carbon content in cast iron is __________ percent.

View solution

Q. Screws are specified by their __________ diameters.

View solution

Q. The stress at which extension of the material takes place more rapidly as compared to the increase in load is termed as the __________ point of the material.

View solution