Question
a.
independent of
b.
inversely proportional to
c.
directly proportional to
d.
none of these
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A fluid is termed as the Newtonion fluid, when the shear stress is __________ the velocity gradient.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the
View solution
Q. When the wet steam is throttled but still remains wet at the exit of the throttle valve, then its temperature & dryness fraction respectively
View solution
Q. Limestone addition in the blast furnace is done to flux __________ present in the raw materials.
View solution
Q. The 'transition temperature' for ductile to brittle behaviour of steel increases with increase in the __________ content in steel.
View solution
Q. The burnout heat flux in the nucleate boiling regime is not a function of the
View solution
Q. The approximate height of a blast furnace having a useful volume of 2000 m³ is about __________ metres
View solution
Q. The cathode in an electrochemical cell always carries
View solution
Q. An oxidation process is accompanied with decrease in the
View solution
Q. Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel & copper having relatively higher melting points. Which of the following is not a hot dipping process ?
View solution
Q. Nusselt number/Biot number varies
View solution
Q. Out of the following, maximum temperature drop for a given heat flow & for the same thickness will be in the case of
View solution
Q. Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed in case of heat exchanger of the type
View solution
Q. Rockwell number represents the
View solution
Q. Which of the following fastening devices has its both ends threaded ?
View solution
Q. Duralumin is an alloy of aluminium and copper. Percentage of copper in duralumin is
View solution
Q. Copper is not present as an alloying constituent in
View solution
Q. Lead is added to 60:40 brass primarily to improve
View solution
Q. Air intake for an air compressor should be preferably taken from
View solution
Q. Current asset of a factory includes the
View solution
Q. If a solid is compressed adiabatically in its elastic range, its __________ remains constat
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
