Q. Which of the following relatively employs the highest heat transfer surface area in a high pressure boiler ?

View solution

Q. Ester is formed, when an alcohol reacts with

View solution

Q. Which of the following accounts for maximum loss of energy in a coal fired boiler ?

View solution

Q. Presence of sulphur in the fuel fired in a furnace

View solution

Q. Boiling temperature of carbon dioxide at atmospheric pressure is __________ °C.

View solution

Q. Eutectoid reaction for iron-carbon system occurs at a temperature of __________ °C.

View solution

Q. A thermally thin body is the one for which

View solution

Q. Air refrigeration cycle is used in the air crafts, because of

View solution

Q. Failure of a material is attributed to __________ if it fails below its yield point.

View solution

Q. Protection of ship hulls against sea water corrosion is done by coating with zinc because of the fact that zinc compared to iron is

View solution

Q. Which of the following pairs regarding the effect of alloying elements in steels are not matched correctly ?

View solution

Q. The maximum axial compression stress during cold upsetting of a cylinderical rod of radius (r) occurs at

View solution

Q. Electrode potential is not concerned with the measurment of

View solution

Q. __________ column is preferred to be used, when a high liquid hold up is required in a reactor for gas-liquid reaction.

View solution

Q. Tungsten in high speed steel is responsible for its

View solution

Q. Heat transfer by radiation from a hot body will be most rapid, if its surface is __________ because of its higher emissivity.

View solution

Q. Reduction reaction involves the

View solution

Q. Specific heat of an ideal gas depends upon its

View solution

Q. In case of compression of one kg of air, the work done will be the least, when the value of polytropic index 'n' is

View solution

Q. A __________ type pressure sensing element is commonly used in aneroid barometer.

View solution