Question
a.
impact strength
b.
percent elongation
c.
hardness
d.
both 'b' & 'c'
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. With increasing carbon percent in steel beyond 0.8%, its ultimate tensile strength (UTS) and __________ is not affected.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Unit molar solution of __________ is the best conductor of electricity.
View solution
Q. A coal with high __________ content will ignite most easily.
View solution
Q. The weight of a body at the centre of the earth is
View solution
Q. For the same heat input & compression ratio, efficiency of Otto cycle is higher than that of diesel cycle, because in Otto cycle.
View solution
Q. The single most imortant requirement for a turbine blade material is
View solution
Q. Pick out the correct statement.
View solution
Q. Ageing of steel refers to the
View solution
Q. When dry bulb temperature & wet bulb temperature of moist air is the same, it means that the
View solution
Q. When metals are heated to high temperature, their __________ increases in general.
View solution
Q. A friction lighter is normally used for lighting gas welding torch, because of the reason that
View solution
Q. Semi-conductors normally employ __________ bonding.
View solution
Q. High endurance limit of carburised machine parts is because of the fact that carburisation
View solution
Q. In __________ process, there is an increase in entropy with no degradation of energy.
View solution
Q. Which of the following is categorised as the plastic welding ?
View solution
Q. In spite of large heat transfer co-efficients in boiling liquids, fins are used advantageously, where the entire surface is exposed to __________ boiling.
View solution
Q. Other parameters remaining same, the recrystallisation temperature of an alloy is lowered, when
View solution
Q. __________ are normally subjected to sub-zero treatment.
View solution
Q. Induced draft fans provided in large thermal power plant boilers have __________ blades.
View solution
Q. Which of the following has the highest value of refractive index ?
View solution
Q. Use of economiser in a boiler plant reduces the fuel consumption for steam generation by about __________ percent.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!