Question
a.
It results in corrosion due to the condensation on the flue gas side of the economiser tubes due to handling of low temperature water.
b.
Economiser tube life increases due to handling of low temperature water.
c.
Heat transfer efficiency of economiser increases due to picking up high heat from the flue gases.
d.
Scale formation rate on economiser tubes increases.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. What is the effect on the performance of the economiser in the thermal power plant boiler, if the feed water temperature is very low due to preheaters being out for repairs or...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A good abrasive
View solution
Q. Out of the following, __________ pipe is the least corrosion resistant.
View solution
Q. In order to protect the aquatic creatures, the dissolved oxygen content in fresh water stream should never be less than __________ PPm.
View solution
Q. For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm³) while the C.V. is same on weight basis (i.e., kcal/kg) ?
View solution
Q. Sheardising process is used for
View solution
Q. Mechanism/phenomenon involved in the improvement of fatigue strength of a material by shot peening is the
View solution
Q. Springs are not made of
View solution
Q. Pick out the wrong statement.
View solution
Q. Monazite deposits constitute an important source for the following metal.
View solution
Q. α-rays are
View solution
Q. The bulk modulus of a material with Poisson's ratio of 0.5 is equal to
View solution
Q. Compression ratio of an I.C. engine is the ratio of the
View solution
Q. Two stroke engine compared to a four stroke engine has
View solution
Q. Ferrites are __________ magnetic.
View solution
Q. The pH value is the measure of hydrogen ion concentration in a solution. The term pH stands for the __________ in the solution.
View solution
Q. Addition of beryllium to copper is done mainly to produce a/an __________ alloy.
View solution
Q. Resilience of a material is important, when it is subjected to
View solution
Q. Existence of velocity potential implies that the fluid is
View solution
Q. The velocity of sound in air is independent of changes in its
View solution
Q. The Al₂O₃ content of cryolite in Hall-Heroult's cell is maintained between __________ percent.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
