Q. The capacity of a spring to store energy is called the spring form co-efficient. Stiffness of a spring is measured by the

View solution

Q. Which of the following materials has the maximum shrinkage allowance ?

View solution

Q. Vibration upto 100 kilo hertz can be most accurately measured by a __________ type accelerometer.

View solution

Q. Yield strength of a material is determined by the __________ test.

View solution

Q. In fluid flow, and heat and mass transfer, one encounters (i) kinematic velocity (μ), (ii) molecular diffusivity (θ) and thermal diffusivity (α). The units of these quantities are.

View solution

Q. Window panes of aeroplanes are normally made of

View solution

Q. __________ flux is used for the extraction of metal from its self fluxing ores.

View solution

Q. Good design of the casing of a centrifugal pump aims at minimising the

View solution

Q. Which of the following is not a dielectric material ?

View solution

Q. Magnetic permeability of iron is increased by its

View solution

Q. The materials which fracture even at small strains are termed as brittle, while those materials which exhibit an appreciable deformation before failure are termed as

View solution

Q. Material of construction of foundary crucible is

View solution

Q. Young's modulus of a material is the measure of its

View solution

Q. Which of the following is not used as a bearing material ?

View solution

Q. Brass parts with high residual tensile stress at the surface are susceptible to season cracking (i.e. spontaneous cracking occuring on exposure to atmospheric corrosion), if its zinc percentage is more than

View solution

Q. Water flow in the river during flood can be categorised as the __________ flow.

View solution

Q. Basicity [%Cao + %MgO/% SiO₂) of the slag in Indian blast furnace is in the range of

View solution

Q. Out of the following, the dimensionless quantity is

View solution

Q. When a copper ball is heated, the largest percentage increase will be in its

View solution

Q. Which of the following hardness tests uses the depth of penetration caused by the indentor as the parameter for arriving at the hardness value of a material ?

View solution