Question
a.
has very high velocity.
b.
has very high pressure.
c.
is brought to rest by gradually closing a valve.
d.
is suddenly brought to rest by closing a valve.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Water hammer in pipelines results, when the flowing fluid
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The preferred alloying element for low temperature applications of steel is
View solution
Q. Production of one ton of steel plate in a modern integrated steel plant in India consumes about __________ kWh of electricity.
View solution
Q. Ceramic tips for the cutting tool are prepared from __________ powder.
View solution
Q. Fatigue strength of a metal is improved by
View solution
Q. Saturated steam at a pressure of 25 kg/cm² is throttled to attain 5 kg/cm² . Then the outcoming steam will be
View solution
Q. An "orange peel" effect is observed
View solution
Q. Which of the following is a boiler accessory i.e., not a boiler mounting ?
View solution
Q. Which of the following forces does not act on a fluid at rest ?
View solution
Q. Density in the solid state is slightly less than that in its liquid state, in case of
View solution
Q. Strain hardening effect in metals subjected to cold working is due to the __________ mechanism.
View solution
Q. __________ number determines whether the fluid flow in an open channel is supercritical, critical or sub-critical.
View solution
Q. Which of the following emissions in the exhaust gas of an I.C. engine causes the formation of photochemical smog?
View solution
Q. If Reynolds number is greater than 1, then the
View solution
Q. The type of pump used for lifting large quantity of sewage is a __________ pump.
View solution
Q. Which of the following metals is not subjected to electrolytic refinning/purification?
View solution
Q. The most important function of a washer is to provide bearing area and washers are normally specified by their hole diameters. The diameter of washer as compared to the nut is
View solution
Q. The hardenability of steel decreases with
View solution
Q. Pick out the correct statement about the condensation.
View solution
Q. Change in volume of metals from absolute zero temperature to their melting points is
View solution
Q. Wohler test is a destructive test to find out the __________ strength of a prepared metal specimen.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
