Q. Internal cracks in drawn bars are due to

View solution

Q. Yield strength of a polycrystalline metal with an average grain size, d, is proportional to

View solution

Q. Pick out the wrong statement:

View solution

Q. The tensile strength of plastics ranges from __________ kg/mm².

View solution

Q. Grain hardness is measured by the __________ hardness testing method.

View solution

Q. The thermal efficiency of a heat engine giving an output of 4 KW with an input of 10000 Joules/sec is __________ percent.

View solution

Q. During brazing, if the fluxes are entrapped, it results in the

View solution

Q. Maximum heat dissipation occurs from a steel wire (k = 0.5 W/m. k) of 15 mm diameter exposed to air (h = 20W/m² .k), when the insulation thickness is __________ mm.

View solution

Q. All modes of heat transfer i.e., conduction, convection & radiation occur in case of the

View solution

Q. The standard instrument used for calibrating the load applied by universal testing machine is called

View solution

Q. The reductant used in the extraction of magnesium from calcined dolomite via Pidgeon's process is

View solution

Q. With increase in pressure, the saturation temperature of steam

View solution

Q. 'Sterilised zone' around a hazardous chemical industry is an area with __________ km radius around it, in which the total population/inhabitants should be less than 20000 preferably in the upwind direction.

View solution

Q. Pick out the wrong statement. Termination of polymerisation reaction occurs, if the

View solution

Q. A thin, flat & square plate measuring 2 m x 2 m is freely hanging in ambient air at 25°C. It is exposed to the solar radiation falling on one side of the plate at the rate of 500 W/m² . The plate temperature will remain constant at 30°C, if the convective heat transfer co-efficient is __________ W/m² °C.

View solution

Q. The maximum value, which the residual stress in a material can reach is the __________ of the material.

View solution

Q. What is the critical radius of insulation (cms) for a metallic cylinder, if the convective heat transfer co-efficient with the ambient atmosphere is 5 W/m². °K ? Thermal conductivity of metal and insulation material are 40 and 0.1 W/m.°K respectively.

View solution

Q. Which set of materials is used as a moderator in nuclear reactor ?

View solution

Q. Malleabilisation heat treatment is performed on

View solution

Q. For hardening high alloy steel, it is to be heated slowly and uniformly to avoid

View solution