Q. The best lubricants for a machine working at high temperature & load is

View solution

Q. One face of a furnace wall is at 1030°C and the other face is exposed to room temperature (30°C). If the thermal conductivity of furnace wall is 3 W . m⁻¹ . k⁻¹ and the wall thickness is 0.3 m, the maximum heat loss (in W/m) is

View solution

Q. Which of the following is not a principal alloying element for the structural steel?

View solution

Q. Metalloids

View solution

Q. Pick out the wrong statement

View solution

Q. Lead is poured into the joints between two __________ pipes.

View solution

Q. 'Ice point' is designated on Farenhite temperature scale by

View solution

Q. The phenomenon occurring during explosion of a hydrogen bomb is

View solution

Q. Square steel key is normally strong in failure by shear & crushing. Keys are normally made of __________ steel bars.

View solution

Q. Nitriding of a steel part does not increase its

View solution

Q. __________ of grey cast iron produces white cast iron.

View solution

Q. As the fluid flow rate increases, the float of the rotameter

View solution

Q. The best guide to judge the general quality of water is the measurement of its

View solution

Q. Wrought iron is not

View solution

Q. Which of the following is the largest quantum of pressure?

View solution

Q. Which of the following is not a charge material for cupola ?

View solution

Q. Which of the following is an undesirable property of slag produced during the pyrometallurgical method of metal extraction from its ore ?

View solution

Q. Runga-Kutta method is used to solve a/an

View solution

Q. Recrystallisation temperature of steel is __________ °C.

View solution

Q. Pressure required to increase the density of water by about 1% is __________ atmosphere.

View solution