Question
a.
greater than that for uninsulated steam pipe.
b.
less than that of the uninsulated steam pipe.
c.
equal to that of the uninsulated steam pipe.
d.
less than the steam pipe with 5 cms insulation.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A 10 cm diameter steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Fouling factor
View solution
Q. In case of vertical tube evaporator, with increase in liquor level, the overall heat transfer co-efficient
View solution
Q. The steam ejector is used to
View solution
Q. For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area
View solution
Q. The thermal efficiency of a reversible heat engine operating between two given thermal reservoirs is 0.4. The device is used either as a refrigerator or as a heat pump between the same reservoirs. Then the coefficient of performance as a refrigerator (COP)R and the co-efficient of performance as a heat pump (COP)HP are
View solution
Q. Crystal size in a continuous crystalliser depends upon the
View solution
Q. Heat waves
View solution
Q. Air is best heated with steam in a heat exchanger of
View solution
Q. Which of the following is generally considered as opaque surface towards radiations?
View solution
Q. Black liquor generated during paper manufacture is concentrated in a
View solution
Q. When vaporisation takes place directly at the heating surface, it is called
View solution
Q. Steam consumption in kg/hr in case of an evaporator is given by (where, C & E are capacity the economy of the evaporator respectively)
View solution
Q. With increase in temperature, the thermal conductivity of non-metallic amorphous solids
View solution
Q. Fourier's law applies to the heat transfer by
View solution
Q. The equivalent diameter for pressure drop is __________ that for heat transfer.
View solution
Q. Controlling heat transfer film co-efficient is the one, which offers __________ resistance to heat transfer.
View solution
Q. The heat flux (from outside to inside) across an insulating wall with thermal conductivity, K= 0.04 W/m.°K and thickness 0.16m is 10 W/m². The temperature of the inside wall is - 5°C. The outside wall temperature is
View solution
Q. Thermal conductivity of a conducting solid material depends upon its
View solution
Q. Pick out the wrong statement.
View solution
Q. Shell side pressure drop in a shell and tube heat exchanger does not depend upon the
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
