Q. A __________ surface has the maximum thermal emissivity out of the following.

View solution

Q. Radiant energy received by a body is proportional to (where, d = the distance between the object emitting radiation and that receiving it.)

View solution

Q. Film boiling is usually not desired in commercial equipments, because

View solution

Q. For the same heat transfer area and the terminal conditions, the ratio of the capacities of a single effect evaporator to a triple effect evaporator is

View solution

Q. The variation of thermal conductivity of a metal with temperature is often correlated using an expression of the form K = K₀ + at. where, K is the thermal conductivity and T is the temperature (in °K). The units of 'a' in SI system will be

View solution

Q. Film condensation is promoted on a/an __________ surface.

View solution

Q. Dietus-Boelter equation cannot be used for molten metals mainly due to its very low

View solution

Q. If Prandtl number is greater than the Schmidt number, then the

View solution

Q. Which of the following accessories is provided in the vapor line of an evaporator for removing the entrained liquid ?

View solution

Q. Rate of heat transfer by vaporisation from pools of water is affected by the

View solution

Q. Multiple effect evaporators are commonly used in the manufacture of

P. Paper
Q. Superphosphate
R. Sugar
S. Fats

View solution

Q. Which of the following has the highest thermal conductivity ?

View solution

Q. For specified tube outside diameter, higher BWG means higher

View solution

Q. Pick out the wrong statement.

View solution

Q. In case of a vertical tube evaporator, with increase in the liquor level, the __________ is increased.

View solution

Q. Electromagnetic radiations propagate in vacuum with a velocity of __________ metre/second.

View solution

Q. Heat flux is the time rate of heat transfer per unit

View solution

Q. Nusselt number (for forced convection heat transfer) is a function of the __________ number.

View solution

Q. Pick out the wrong statement.

View solution

Q. Which type of heat exchanger is preferred for heavy heat loads ?

View solution