Q. If the baffle spacing in a shell and tube heat exchanger increases, then the Reynolds number of the shell side fluid

View solution

Q. The heat transfer by radiation from a mild steel surface is to be reduced by reducing the emissivity of the surface. This can be best achieved by

View solution

Q. __________ paint has the maximum absorption coefficient.

View solution

Q. Which of the following is unimportant in forced convection ?

View solution

Q. Steam is to be condensed in a shell and tube heat exchanger, 5 m long with a shell diameter of 1 m. Cooling water is to be used for removing the heat. Heat transfer co-efficient for the cooling water, whether on shell side or tube side is the same. The best arrangement is

View solution

Q. In a multiple effect evaporator, the effect of boiling point elevation is to

View solution

Q. Dropwise condensation occurs on __________ surfaces.

View solution

Q. Heat transfer efficiency leading of energy conservation in a heat exchanger can be achieved by

View solution

Q. Trap is used to remove __________ from steam pipe lines.

View solution

Q. A composite flat wall of a furnace is made of two materials 'A' and 'B'. The thermal conductivity of 'A' is twice of that of material 'B', while the thickness of layer of 'A' is half that of B. If the temperature at the two sides of the wall are 400 and 1200°K, then the temperature drop (in °K) across the layer of material 'A' is

View solution

Q. Tube pitch is the __________ of tube diameters and the clearances.

View solution

Q. With increase in the distance between the heat source and the object receiving the heat, the radiation heat transfer

View solution

Q. The heat flux in the nucleate boiling regimes is proportional to (where, ΔT = excess temperature)

View solution

Q. In a 1-1 cocurrent heat exchanger, if the tube side fluid outlet temperature is equal to the shell side fluid outlet temperature, then the LMTD is

View solution

Q. A body is called grey if the monochromatic emissivity of the body is

View solution

Q. In an extended surface heat exchanger, fluid having lower co-efficient

View solution

Q. In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is

View solution

Q. The equivalent diameter for the annulus of a double pipe heat exchanger, whose inner pipe has fins on the outside is __________ compared to the same size pipes without fins.

View solution

Q. Natural convection is characterised by

View solution

Q. Nusselt number for full developed, laminar, constant property flow in a pipe at uniform heat flux is

View solution