Q. Maximum heat transfer rate is obtained in __________ flow.

View solution

Q. In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface.

View solution

Q. The ratio of velocity head to tube side return loss in case of a multipass shell and tube heat exchanger is

View solution

Q. Terminal point temperature differences between fluids in case of a heat exchanger is termed as

View solution

Q. LMTD can't be used as such without a correction factor for the

View solution

Q. Fqra cold viscous feed, backward feed gives __________ than forward feed.

View solution

Q. Walls of a cubical oven are of thickness l, and they are made of material of thermal conductivity k. The temperature inside the oven is 100°C and the inside heat transfer co-efficient is 3k/l. If the wall temperature on the outside is held at 25°C, what is the inside wall temperature in degree centigrade ?

View solution

Q. The characteristic dimensionless groups for heat transfer to a fluid flowing through a pipe in laminar flow are

View solution

Q. Heat transfer rate described by Fourier's law will decrease, if the __________ increases.

View solution

Q. A black body does not __________ radiation.

View solution

Q. The capacity of double-effect evaporator is less than half of the capacity of two single effects, each of which is operating over same terminal temperature difference, when the

View solution

Q. Peclet number (Pe) is given by

View solution

Q. Nusselt number is the ratio of the

View solution

Q. Prandtl number is the ratio of

View solution

Q. Which of the following parameters is increased by use of finned tube in a multipass shell and tube heat exchanger ?

View solution

Q. Forced circulation evaporators are useful for the concentration of viscous, salting and scale forming liquors. Which of the following is a forced circulation evaporator?

View solution

Q. "The ratio of the total emissive power to the absorptivity for all bodies is same at ther-mal equilibrium". This is __________ law.

View solution

Q. View factor is important in heat transfer by

View solution

Q. The advantage of using a 1 - 2 shell and tube heat exchanger over a 1 - 1 shell and tube heat exchanger is

View solution

Q. For a multipass shell and tube heat exchanger, the LMTD correction factor is always

View solution