Q. Overall thermal resistance for conductive heat transfer through a series of flat resistances is equal to the

View solution

Q. Double pipe heat exchangers are preferably useful, when

View solution

Q. Removal of __________ heat is involved in the condensation of a vapor under saturated conditions.

View solution

Q. In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.

View solution

Q. When the ratio of the Grashoff number and to the square of Reynolds number is one, the dominant mechanism of heat transfer is

View solution

Q. The purpose of providing bleed points in the evaporator is to

View solution

Q. Water always boils when its

View solution

Q. A multiple effect evaporator as compared to a single effect evaporator of the same capacity has

View solution

Q. When does the heat generated by fluid friction becomes appreciable compared to the heat transferred between the fluids ?

View solution

Q. The Sieder-Tate correlation for heat transfer in turbulent flow in pipe gives Nu α Re^0.8, where, Nu is the Nusselt number and Re is the Reynolds number for the flow. Assuming that this relation is valid, the heat transfer co-efficient varies with the pipe diameter (D) as

View solution

Q. A long iron rod initially at a temperature of 20°C has one end dipped in boiling water (100°C) at time, t = 0. The curved surface of the rod is insulated so that heat conduction is one dimensional in the axial direction. The temperature at a distance 100 mm from the dipped end becomes 40°C at time, t = 200 s. The same temperature is achieved at a distance of 200 mm from the dipped end at time

View solution

Q. LMTD for evaporators & condensers for a given terminal parameters & set of conditions for counterflow is equal to that for parallel flow. In such heat exchangers, with one of the fluids condensing or evaporating, the surface area required is the least in the __________ flow.

View solution

Q. Thermal diffusivity of a material

View solution

Q. h.D/K is called the __________ number.

View solution

Q. Prandtl number is the ratio of

View solution

Q. Conductance is given by(where, x = thickness, A = heat flow area, K = thermal conductivity.)

View solution

Q. Heat flux, as defined in heat flow is analogous to __________ in electricity flow.

View solution

Q. The wavelength at which the maximum monochromatic emissive power occurs for a black body, is (where, T = absolute temperature of the black body)

View solution

Q. Which is the most suitable for cold viscous feed?

View solution

Q. Dropwise condensation is promoted on a/an __________ surface.

View solution