Question
a.
highest in last effect
b.
lowest in last effect
c.
same in all effects
d.
dependent on the number of effects
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a forward feed multiple effect evaporator, the pressure is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation will
View solution
Q. Which of the following situations can be approximated to a steady state heat transfer system ?
View solution
Q. Sensible heat absorbed by 1 lb of water when it is heated from 32 to 212°F may be around __________ BTU.
View solution
Q. In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid
View solution
Q. With increase in temperature, the total emissivity of conductors
View solution
Q. Loss of heat from untagged steam pipe to the ambient air is by
View solution
Q. Fruit juice (a heat sensitive material) can be concentrated in a __________ evaporator.
View solution
Q. Tubes are held between top and bottom tube sheets in Calenderia type evaporator by keeping
View solution
Q. Nusselt number is the ratio of the temperature gradient at the wall to
View solution
Q. The Stefan-Boltzman constant depends on the
View solution
Q. The units of resistance to heat transfer is
View solution
Q. Thermal conductivity of a gas at low density, __________ with increase in temperature.
View solution
Q. Nusselt number is a function of Prandtl number and __________ number of fluid in natural convection heat transfer.
View solution
Q. __________ heat exchanger is used for chilling oil to be dewaxed.
View solution
Q. It is not recommended to use a 1-2 shell and tube heat exchanger for a particular heat duty, whenever the LMTD correction factor is
View solution
Q. Pick out the wrong statement.
View solution
Q. In sub-cooled boiling,
View solution
Q. With increase in temperature, the thermal conductivity of a gas
View solution
Q. Which of the following parameters of the fluid is not very important, while deciding its route in a shell and tube heat exchanger?
View solution
Q. Corrosiveness of steam condensate is due to the presence of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!