Question
a.
rapid absorption rates and good heat transfer characteristics.
b.
improved flooding characteristics.
c.
low pressure drop on pumping.
d.
all (a), (b) and (c).
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Low viscosity absorbent is preferred for reasons of
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Mass transfer co-efficient (K) and diffusivity (D) are related according to film theory as
View solution
Q. Drying operation under vacuum is carried out to
View solution
Q. Air initially at 101. 3 kPa and 40°C and with a relative humidity of 50%, is cooled at constant pressure to 30°C. The cooled air has a
View solution
Q. Separation of two or more components of a liquid solution can not be achieved by
View solution
Q. Stefan's law describes the mass transfer by
View solution
Q. At minimum reflux ratio for a given separation
View solution
Q. The mass diffusivity, the thermal diffusivity and the eddy momentum diffusivity are same for, NPr = NSc = __________
View solution
Q. Dew point of a gas-vapour mixture
View solution
Q. In a packed absorption tower, if the equilibrium and operating lines are both straight lines, then the ratio, HETP/HTUOG __________ the absorption factor.
View solution
Q. Which of the following plays an important role in problems of simultaneous heat and mass transfer ?
View solution
Q. In case of an absorber, the operating
View solution
Q. Total reflux in a distillation operation requires minimum
View solution
Q. The amount of steam required per unit quantity of distillate in case of steam distillation will be reduced by
View solution
Q. The difference of wet bulb temperature and adiabatic saturation temperature of unsaturated mixture of any system is
View solution
Q. Fenske's equation for determining the minimum number of theoretical stages in distillation column holds good, when the
View solution
Q. When the temperature and humidity of air is low, we usually use __________ draft cooling tower.
View solution
Q. Make up water is required in a cooling tower to replace the water lost by
View solution
Q. Which of the following quantities need not be fixed before starting the design of a co-current absorber ?
View solution
Q. Mass transfer co-efficient of liquid is
View solution
Q. Absorption accompanied with chemical reaction is exemplified by the absorption of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
