Q. When an unsaturated air-water mixture is heated at constant pressure, then

View solution

Q. During sensible cooling process

View solution

Q. Experiments were conducted to determine the flux of a species A in a stagnant medium across a gas-liquid interface. The overall mass transfer co-efficient based on the liquid side for dilute systems for the above was estimated to be 4 x 10⁻³ kg mole/m².s. The equilibrium data for the system is given as y = 2x. The flux across the interface (in kg mole/m² .s) for bulk concentrations of A in gas phase and liquid phase as y = 0.4 and x = 0.01 respectively is

View solution

Q. Leaching of coarse solid lumps is also termed as

View solution

Q. The main reason for dividing a tall packed tower into series of small towers is to

View solution

Q. Co-current absorbers are usually used when the gas to be dissolved in the liquid is

View solution

Q. At what percentage (by volume) of alcohol composition, it forms an azeotrope with water ?

View solution

Q. The overall mass transfer co-efficient for the absorption of SO₂ in air with dilute NaOH solution can be increased substantially by

View solution

Q. Flooding results in

View solution

Q. For the air water system under ambient conditions, the adiabatic saturation temperature and the wet bulb temperature are nearly equal, because

View solution

Q. In an operating distillation column, the

View solution

Q. __________ is used as an 'entrainer' for the separation of acetic acid-water mixture by distillation.

View solution

Q. Rotary dryers cannot handle __________ materials.

View solution

Q. Pick out the correct statement.

View solution

Q. An example of elutioh is

View solution

Q. The operating line for an absorber is curved, when plotted in terms of

View solution

Q. Relative volatility does not change appreciably with the change in

View solution

Q. Boiling point diagram is not affected by the ambient

View solution

Q. The dew point of a saturated gas phase equals the __________ temperature.

View solution

Q. A solid material shows case hardening properties while drying. Which of the following should be controlled to control the drying process ?

View solution