Q. Entrainer used in azeotropic distillation should

View solution

Q. In case of steam distillation, the steam leaving the liquid is not completely saturated with distillate vapour, because

View solution

Q. Pick out the wrong statement.

View solution

Q. Leaching of coffee from coffee beans is done by

View solution

Q. For contacting a highly soluble gas with a liquid

View solution

Q. During drying operation, it is easier to remove the __________ moisture.

View solution

Q. With increase in solvent rate, the number of transfer units, NtoG, for a fixed degree of absorption from a fixed amount of gas

View solution

Q. Ion exchange process is similar to

View solution

Q. A distillation column with N plates is being operated under normal conditions. At some point of time, the operation is shifted to total reflux condition (i.e., no product and residue are being withdrawn and feed to the column is stopped). At the new steady state,

View solution

Q. The absorption factor is defined as (where, L = liquid flow rate, G = gas flow rate and, m = slope of the equilibrium line)

View solution

Q. Smoke is an example of

View solution

Q. Which of the following adsorbant is used in the refinning of sugar ?

View solution

Q. Stacked packing compared to dumped packing

View solution

Q. In McCabe-Thiele method of theoretical plate calculation for a distillation column, the operating lines of stripping and rectifying sections coincide with the diagonal at __________ reflux.

View solution

Q. Dryer widely used in a textile industry is __________ dryer.

View solution

Q. Solvent used in extractive distillation

View solution

Q. Air at a particular humidity is heated in a furnace. The new dew point

View solution

Q. In a packed tower, the value of HETP equals HTUOG, when the equilibrium and the operating lines are (where, HETP = height equivalant to a theoretical plate HTUOG = overall gas phase height of a transfer unit)

View solution

Q. The vapour pressure exerted by the moisture contained in a wet solid depends upon the

View solution

Q. Heat load in a cooling tower

View solution