Question
a.
uranium from its ore
b.
water from petrol
c.
ammonia from coke oven gas
d.
mustard oil from mustard seed
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Removal of __________ exemplifies an adsorption unit operation.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Can the efficiency of a plate in the distillation tower be greater than 100% ?
View solution
Q. With increase in the mass velocity of the gas, the rate of drying during the constant rate period __________ , if the conduction and radiation through the solid are negligible.
View solution
Q. For gas absorption, low viscosity solvents are preferred, because of their
View solution
Q. To remove all the moisture from a wet solid it requires exposure to __________ air.
View solution
Q. Polar organic compounds are normally used as separating agents for the azeotropic and extractive distillation. Which of the following is the most important factor to be considered for the choice of the separating agent for extractive distillation ?
View solution
Q. As the reflux ratio increases, the slope of the operating line for rectifying section
View solution
Q. Cox chart, which is useful in the design of distillation column particularly for petroleum hydrocarbons, is a plot of (where, P = vapor pressure, T = temperature)
View solution
Q. The unit of volumetric diffusivity is
View solution
Q. For a ternery mixture, in which equilateral triangular co-ordinate is used in leaching and extraction, a __________ of the equilateral triangular co-ordinates.
View solution
Q. Steady state temperature reached by a small amount of liquid evaporating into a large amount of unsaturated vapour-gas mixture is called the __________ temperature.
View solution
Q. The Reynolds number of the liquid was increased 100 fold for a laminar falling film used for gas-liquid contacting. Assuming penetrating theory is applicable, the fold increase in the mass transfer co-efficient (Kc) for the same sytem is
View solution
Q. The slope of 9-line is determined by the
View solution
Q. In steam distillation, the
View solution
Q. Which of the following can be calculated theoretically using steam table and Dalton's law of partial pressure; if the relative humidity and dry bulb temperature of moist air is known ?
View solution
Q. Which of the following parameters remains constant during chemical dehumidifica-tion?
View solution
Q. Drying of a solid involves __________ transfer.
View solution
Q. Mechanism of moisture removal in case of freeze drying of food stuff is by
View solution
Q. The dew point of an unsaturated gas-vapor mixture does not depend upon the __________ of the mixture.
View solution
Q. Which is not concerned directly with mass transfer ?
View solution
Q. In case of cooling towers, the ratio of the rates of heat and mass transfer is indicated by the __________ number.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!