Q. The process employing desorption of the absorbed solute by a solvent is called

View solution

Q. Steam distillation is used for separation of high boiling

View solution

Q. The feed to fractionating column is changed from saturated vapour to saturated liquid. If the separation and reflux ratio remains unchanged, the number of ideal stages will

View solution

Q. Rose oil is extracted from rose leaves using __________ distillation.

View solution

Q. Hypersorption refers to a __________ process.

View solution

Q. Dry bulb temperature of the gas is __________ the wet bulb temperature.

View solution

Q. Decoction refers to the use of solvent

View solution

Q. Flash distillation is suitable for separating the constituents of a binary system, which

View solution

Q. The ratio of Murphree plate efficiency to point efficiency is 1 in a __________ flow model.

View solution

Q. The rough value of diffusion co-efficient of water vapor into air at 25°C may be about __________ cm²/sec.

View solution

Q. NSc/NPr is called the

View solution

Q. McCabe-Thiele method

View solution

Q. The film penetration model of mass transfer was enunciated by

View solution

Q. The most economical range of absorption factor is

View solution

Q. Channelling is most severe

View solution

Q. If the overall efficiency and Murphree plate efficiency are equal, then both the equilibrium and operating lines are

View solution

Q. Which of the following operations does not involve leaching ?

View solution

Q. The recovery of pencillin from the acidified fermentation broth is done by

View solution

Q. Unit operation involved in the prilling of urea is

View solution

Q. Molecular seives are porous

View solution