Question
a.
Schmidt
b.
Sherwood
c.
Peclet
d.
Stanton
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Corresponding to Prandtl number in heat transfer, the dimensionless group in mass transfer is the __________ number.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. If a two phase system is in physical equilibrium; then it means that, the
View solution
Q. McCabe-Thiele method of binary distillation does not assume that the
View solution
Q. (NSh/NRe.NSc) is termed in mass transfer operation as the
View solution
Q. In a binary system, separation is very efficient, when the relative volatility is
View solution
Q. Fenske-Underwood equation used for calculating the minimum number of theoretical plates in distillation column is valid for
View solution
Q. The binary diffusivity in gases does not depend upon the
View solution
Q. Berl saddle made of carbon cannot be used for
View solution
Q. 1 kg of a saturated aqueous solution of a highly soluble component A at 60°C is cooled to 25°C. The solubility limits of A are (0.6 kgA/kg water) at 60°C and (0.2 kgA/kg water) at 25°C. The amount in kg of the crystals formed is
View solution
Q. Pick out the wrong statement. Raoult's law does not apply, when the
View solution
Q. Water-ethyl alcohal solution can be concentrated (in respect of alcohal concentration) by __________ distillation.
View solution
Q. L/mG is the expression for
View solution
Q. Extraction of pencillin employs a __________ extraction coloumn.
View solution
Q. In case of gases, the binary diffusivity is proportional to (where, P = pressure)
View solution
Q. As per Gilliland's equation, the diffusivity is
View solution
Q. Pick out the wrong statement.
View solution
Q. A mixture of 10% C₆H₆ vapour in air at 25°C and 750 mm Hg has a dew point of 20°C. Its dew point at 30°C and 700 mm Hg will be around __________ °C.
View solution
Q. Which of the following is not fixed by the process requirements, in the design of absorbers ?
View solution
Q. If the amount of the steam used in steam distillation is increased, the temperature of distillation
View solution
Q. The Hatta number is important in
View solution
Q. When a multistage tray tower uses a minimum reflux ratio, it implies
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!