Question
a.
partial pressure
b.
mole ratio
c.
mole fraction
d.
none of these
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. For a single component absorber, the operating line is straight only when plotted in term of __________ units.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Raschig ring made of procelain cannot be used for treating concentrated
View solution
Q. H₂S present in naphtha reformed gas is removed by absorbing with
View solution
Q. During constant rate drying period, vaporisation rate per unit drying surface area
View solution
Q. Pick out the wrong statement.
View solution
Q. In rectifying section of a continuous distillation column, the
View solution
Q. For a distillation column operating at minimum reflux, the
View solution
Q. A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))
View solution
Q. Flash distillation is suitable for the separation of components
View solution
Q. In Mcabe-Thiele method, at infinite reflux ratio
View solution
Q. Leaching rate is independent of the
View solution
Q. Molality is defined as the number of gm moles of solute per __________ of solvent.
View solution
Q. __________ is concerned with the adsorption equilibria.
View solution
Q. Fractional solvent extraction
View solution
Q. In the layout plan for a vacuum distillation unit, operating at 60 mm Hg, supported by a barometric condenser, the appropriate place for the location of vacuum drum for collecting the distillate will be
View solution
Q. At 750°K and 1 atm, the approximate value of Schmidt number for air is
View solution
Q. Calculation of mass transfer co-efficient is mostly/normally done using __________ theory.
View solution
Q. Which of the following is used for the concentration of rubber latex ?
View solution
Q. Unsaturated air (with dry and wet bulb temperatures being 35 and 25°C respectively) is passed through water spray chamber maintained at 35°C. The air will be
View solution
Q. For absorbing a sparingly soluble gas in a liquid, the
View solution
Q. A natural draft cooling tower is filled with wooden grids, which covers about __________ percent of the tower height.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!