Question
a.
∞
b.
0
c.
1
d.
0.24
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Compressibility factor of a real gas is the ratio of the actual volume to that predicted by ideal gas law. As the pressure of the gas approaches zero, the compressibility factor...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Cᵨ equals Cᵥ at
View solution
Q. Pick out the wrong statement.
View solution
Q. 40 gms each of the methane and oxygen are mixed in an empty container maintained at 40°C. The fraction of the total pressure exerted by oxygen is
View solution
Q. A rigid vessel containing three moles of nitrogen gas at 30°C is heated to 250°C. Assume the average capacities of nitrogen to be Cᵨ = 29.1 J/mole.°C and, Cᵥ = 20.8 J/mole.°C. The heat required, neglecting the heat capacity of the vessel, is
View solution
Q. An oxidation process is accompanied by decrease in the
View solution
Q. Refluxing of part of the distillate in a fractionating column is a 'recycling operation', aimed primarily at
View solution
Q. Which of the following expressions defines the Baume gravity scale for liquids heavier than water ?
View solution
Q. The net heat evolved or absorbed in a chemical process, i.e. total change in the enthalpy of the system is independent of the
View solution
Q. N.T.P. corresponds to
View solution
Q. During a phase change process like sublimation, vaporisation, melting etc., the specific __________ does not change.
View solution
Q. The boiling points for pure water and pure toluene are 100°C and 110.6°C respectively. Toluene and water are completely immiscible in each other. A well agitated equimolar mixture of toluene and water are prepared. If, at a total pressure of one standard atm. exerted by the vapours of water and toluene, the mole fraction of water Xw in the vapour phase satisfies
View solution
Q. Colligative properties of a dilute solution are those, which depend entirely upon the
View solution
Q. Viscosity of atmospheric air may be about __________ centipoise.
View solution
Q. The osmotic pressure of a solution increases, if its __________ is decreased.
View solution
Q. Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m³ . The diffusivity of aniline in air is 0.74x10⁻⁵ m²/s.The numerical value of mass transfer co-efficient is 7.4 x 10⁻³. The rate of evaporation of aniline is 2.97 x 10⁻⁴. Its units are
View solution
Q. In osmosis through a semi-permeable membrane, diffusion of the
View solution
Q. Heat of reaction is not influenced by
View solution
Q. Pick out the wrong conversion formula for the conversion of weight units :
View solution
Q. The elevation in boiling point of a solution is proportional to the __________ of the solution.
View solution
Q. Pick out the wrong statement.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!