Question
a.
potassium hydroxide.
b.
cuprous chloride.
c.
alkaline pyragllol solution.
d.
none of these.
Posted under Fuels and Combustion Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In flue gas analysis by Orsat's apparatus, oxygen is absorbed by
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Natural draft created by the chimney depends upon
View solution
Q. Coke oven gas after passing through return electrostatic tar precipitator (RETP) is used for the
View solution
Q. Calorific value of a typical dry anthracite coal may be around __________ Kcal/kg.
View solution
Q. The most matured coal out of the following is
View solution
Q. Presence of force moisture in coal is most disadvantageous during its
View solution
Q. Tar is a better fuel than furnace oil, because of its
View solution
Q. With increase in moisture content of coal, its
View solution
Q. Main constituent of natural gas is
View solution
Q. For the case of a fuel gas undergoing combustion with air, if the air/fuel ratio is increased, the adiabatic flame temperature will
View solution
Q. Pick out the wrong statement.
View solution
Q. Which of the following has the highest gross calorific value ?
View solution
Q. A liquid/gaseous fuel containing hydrocarbons and high amount of sulphur is burnt with 40% excess air. The flue gas still contains large amount of carbon monoxide. This may be due to the
View solution
Q. Efficient burning of anthracite coal requires
View solution
Q. C/H ratio is the minimum in case of
View solution
Q. Ignition temperature decreases progressively from anthracite to lignite, because
View solution
Q. Which of the following fuel gases is heavier than air ?
View solution
Q. Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.
View solution
Q. Theoretical flame temperature of a fuel is that temperature which is attained, when the fuel is completely burnt using theoretical amount of air in
View solution
Q. Use of preheated air for combustion of fuel in the furnace, increases the
View solution
Q. Which of the following can be made into briquettes without the use of a binder ?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
