Question
a.
The pressure drop due to the caps & slots and the static submergence should be as high as practicable for reasonable operation.
b.
Tendency towards stable operation is increased by increasing the skirt clearance of the caps, lowering the rate of liquid flow per unit plate width or increasing the spacing between the caps.
c.
The dimensionless ratio of liquid gradient to pressure drop head caused by the bubble cap assembly should be less than 0.4.
d.
none of these.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pick out the wrong statement pertaining to the design of the bubble cap tray of a distillation column to give stable operation and even vapour distribution.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Speed of the drum of the rotary vacuum filter normally ranges from __________ rpm.
View solution
Q. A stuffing box is used for
View solution
Q. Pressure drop (Δp) and the superficial gas mass velocity (G) in case of packed absorption tower operating in the preloading range are related as
View solution
Q. Pick out the wrong statement.
In an agitated vertical cylinderical reaction vessel, the
View solution
Q. The value of fouling factor depends upon the
View solution
Q. In case of bubble cap distillation column of diameter greater than 1.2 metres, the cap diameter is roughly about __________ cms.
View solution
Q. Tube side pressure drop in a 1-2 heat exchanger (for turbulent flow of fluids through the tubes) is about __________ times, that in a 1-1 heat exchanger having the same size & number of tubes and operated at the same liquid flow rate.
View solution
Q. To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of
View solution
Q. In a heat exchanger, shell side fluid velocity can be changed by changing the tube
View solution
Q. Where does the maximum tensile strength occur in a thick cylindrical vessel subjected to internal pressure ?
View solution
Q. It is not desirable to design a heat exchanger for LMTD correction factor, Fᴛ, of less than
View solution
Q. A rivetted joint does not fail by __________ of rivets.
View solution
Q. Triangular pitch tube layout as compared to square pitch in a shell and tube heat exchanger
View solution
Q. Bracket supports are the most suitable for supporting __________ vessels.
View solution
Q. Fresh water carrying pipelines in chemical industries are coloured with __________ color.
View solution
Q. Which of the following material is seldom used for pressure vessel construction ?
View solution
Q. The ratio of shear stress to shear strain is called
View solution
Q. 25 per cent cut segmental baffle means that the baffle
View solution
Q. Liquid/petroleum fuel storage tanks are built underground (as in case of petrol pumps), when the storage capacity is less than __________ kilolitres.
View solution
Q. In a multipass shell and tube heat exchanger, the shell side cross flow area does not depend upon
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!