Question
a.
brackets
b.
skirts
c.
columns
d.
saddles
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Vertical vessels are not supported by
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. With increase in pressure drop (for a given particle size), the dust collection efficiency of a cyclone separator will
View solution
Q. Spherical shaped pressure vessel is considered to be the most ideal, because it can
View solution
Q. An adequate clearance between the tray and the shell wall of a distillation column is provided to
View solution
Q. Overall tray efficiency of a distillation column is the ratio of the number of
View solution
Q. Number of evaporators which can be used in service in a multiple effect evaporation system is limited by the
View solution
Q. Which of the following is used to set the diameter of the distillation column ?
View solution
Q. Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele's method, this method
View solution
Q. The optimum size ratio for two mixed reactors in series depends on the kinetics of the reaction and the conversion level. For reaction orders more than one, the
View solution
Q. In a shell and tube heat exchanger, tube side __________ of the mass velocity.
View solution
Q. Cooling water fouling factors vary in the range of 0.001 to 0.003
View solution
Q. Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter )
View solution
Q. The maximum liquid gradient over a tray must not exceed
View solution
Q. An underdesigned steam trap will
View solution
Q. The slope of the feed line in distillation opeartion is given by (where, q = fraction of the feed stream that is liquid.)
View solution
Q. Needle valves are generally not used for
View solution
Q. Height equivalent to a theoretical plate (HETP) is the height of packing that will give the same separation as one theoretical plate in gas-liquid mass transfer operations like distillation, absorption/stripping and humidification/dehumidification. HETP which is experimentally determined, depends upon the
View solution
Q. Pick out the wrong statement.
View solution
Q. With increase in gas flow rate to fabric surface area ratio (Nm³/hr/m² fabric surface area), the size & the cost of a bag filter
View solution
Q. A head comprises of straight flange section, corner torus, section and central dished section. Crown radius and knuckle radius in a head is related respectively to the
View solution
Q. Accidents in chemical plants are mostly due to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!