Question
a.
strain
b.
stress
c.
modular ratio
d.
none of these
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The units of Young's modulus of elasticity and __________ are the same.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In the design of a shell and tube heat exchanger, the corrosion allowance
View solution
Q. Vertical condenser is advantageous to the horizontal condenser from operation point of view, when
View solution
Q. In common bubble cap distillation column design practice, riser area is approximately equal to (where, Aₐ = Annular passage area, and Sₐ = Slot area)
View solution
Q. Heat transfer co-efficient, hԍ(Kcal/hr.m² .°C) and mass velocity of air, G (kg/hr.m² ) for air flow parallel to the surface in case of constant drying rate in batch drying is related as hԍ = 0.0176G^0.8. But when the flow of air perpendicular to the surface is encountered, this equation changes to
View solution
Q. In the agitators, the power required will be changed with the increase of diameter of agitator (D) as
View solution
Q. Apex angle of conical heads used in the bottom heads of chemical process equipments is usually
View solution
Q. A 'rupture disc' is provided in chemical equipments as an accessory meant for
View solution
Q. In a vertical short tube evaporator (Calendria type), the
View solution
Q. In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a
View solution
Q. In a shell and tube heat exchanger, the shortest centre to centre distance between the adjacent tubes is
View solution
Q. Any shell opening greater than 5 cms for a storage tank must be reinforced for reason of
View solution
Q. The thermal stress in a metallic bar does not depend upon the
View solution
Q. The minimum baffle height should be
View solution
Q. To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
View solution
Q. The normal range of velocity of water in pipes is __________ m/sec.
View solution
Q. Value of Peclet number = 0, is the representative of
View solution
Q. Poisson's ratio of a material is the ratio of unit lateral strain to the unit axial elongation within its elastic limit. The value of Poisson's ratio for structural and pressure vessel steel may be taken as
View solution
Q. Removable connection of tubes to tube sheet is called
View solution
Q. Typical static submergence for bubble cap plate column operating at atmospheric pressure may be around
View solution
Q. In the allocated cap area, bubble caps are generally arranged on equilateral triangular pitch. Number of caps fixed on a plate is with a
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!