Q. Hoop (circumferential) stress induced in a thin walled 'Horton Sphere' used for the storage of liquid ammonia under pressure is

View solution

Q. When one of the fluids is highly corrosive and has fouling tendency, it should

View solution

Q. A/an __________ is used for changing the direction of a pipeline.

View solution

Q. Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.

View solution

Q. Liquid redistribution should be done in a packed tower packed with raschig rings every 6 metres or __________ times the column diameter, whichever is lower.

View solution

Q. Slope of countercurrent flow rotary drier is in the range of __________ meter/metre.

View solution

Q. In case of saddle packing (e.g., berl and intralox saddles), the maximum size of the packing should not exceed __________ of the column diameter.

View solution

Q. Seamless pipe is made

View solution

Q. Pick out the wrong statement pertaining to the design of the distillation column.

View solution

Q. The longitudinal stress induced in a thin walled cylinderical vessel under internal pressure is

View solution

Q. In distillation columns, bubble caps are held in place over trays by

View solution

Q. The buckling tendency of compression members is always in the direction of the

View solution

Q. In case of plain carbon steel, butt welded joints are used for shell plate thickness ≤ __________ cms.

View solution

Q. Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle ?

View solution

Q. A certain pressure vessel manufacturer avoids doing reinforcements calculations for openings by always providing a reinforcing pad extending upto double the diameter of the opening and of the same material and thickness as that of the shell wall. If area compensation is accepted as a code guideline, his approach leads to safe design

View solution

Q. In a __________ rivetted joint, the number of rivets decreases from the innermost row to the outermost row.

View solution

Q. Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about __________ percent of the total thickness.

View solution

Q. Heat transfer co-efficient for a horizontal condenser as compared to a vertical condenser operating under similar conditions is

View solution

Q. Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.

View solution

Q. In condenser, the cooling water is passed in the tube side in a pass arrangement, because

View solution