Q. Rotary kilns meant for calcination of limestone are lined with chrome magnesite in __________ zone.

View solution

Q. The highest melting pure oxide (m.p. > 3000°C) is

View solution

Q. In panel test for spalling resistance, the average face temperature of panel assembly is maintained at __________ °C for 24 hours.

View solution

Q. Which is not an acidic refractory ?

View solution

Q. Natural silica

View solution

Q. Thermal conductivity of refractory bricks

View solution

Q. Dolomite bricks have good resistance to attack by

View solution

Q. Bottom of basic open hearth furnace are constructed of

View solution

Q. Which form of silica has the highest specific gravity ?

View solution

Q. Ceramic recuperators used for waste heat recovery from high temperature flue gas going out of the furnace is made of

View solution

Q. __________ is the measure of the strength of refractory under the combined effect of temperature & load.

View solution

Q. Fireclay bricks are not used in the

View solution

Q. Refractories used in/for __________ should have low thermal conductivity.

View solution

Q. 10 to 30% magnesite is added to chromite to produce chrome-magnesite refractories. Magnesite addition is mainly done to improve the __________ of chromite.

View solution

Q. Silica bricks are never used for lining the

View solution

Q. Which is not a natural insulating material?

View solution

Q. Magnesite refractories are generally not used in the

View solution

Q. __________ is not a single oxiderefractory.

View solution

Q. Hot blast main (carrying air at 1000°C) in blast furnace are lined with __________ bricks.

View solution

Q. High alumina refractory compared to fireclay bricks have

View solution