Q. Nylon-6 as compared to nylon-66 is

View solution

Q. Alkyd resin is a/an

View solution

Q. Most commonly used rubber vulcanisation agent is

View solution

Q. Antioxidants are added to rubber to protect it from the attack of light, heat & atmospheric ozone. Which of the following is an antioxident used in rubber ?

View solution

Q. Maximum consumption of polymers is in

View solution

Q. Low density polythene as compared to high density polythene is

View solution

Q. Phenol formaldehyde is produced by condensation polymerisation. It is also known as

View solution

Q. Polymethyl methacrylate, which is an acrylic resin, is also called

View solution

Q. Silicone resins, which are highly water repellant and has good heat resistance can not be used

View solution

Q. Pick out the wrong statement.

View solution

Q. Which of the following rubbers has the widest service temperature range (-75 to 275°C) ?

View solution

Q. Nylon-66 compared to nylon-6 has

View solution

Q. Scouring is a finishing operation during the manufacture of fibre, which aims at __________ of fibres.

View solution

Q. Which of the following is generally not drawn into fibre ?

View solution

Q. Condensation polymerisation of caprolac-tum is carried out in the reactor maintained at a temperature of __________ °C for producing nylon-6.

View solution

Q. Which of the following is not a natural polymer ?

View solution

Q. In case of wet spinning of polymers, the polymer solution is forced through spinnerates into, a coagulating bath to give a filament form. Wet spinning is not used in case of the __________ fibres.

View solution

Q. Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.

View solution

Q. Which of the following is not the commercial name of polymethylmethacrylate (PMMA) ?

View solution

Q. Density of low density polythene is about __________ gm/c.c.

View solution