Q. The normal stress is the same in all directions at a point in a fluid, when the fluid is

View solution

Q. Head developed by a centrifugal pump depends on its

View solution

Q. Hydraulic mean depth (Dₘ) for a circular pipe of diameter 'D' flowing full is 0.25 D. For a circular channel, at Dₘ = 0.3 D, gives the condition for the maximum

View solution

Q. The head loss in turbulent flow in a pipe varies

View solution

Q. Most commonly used joint in the underground pipe lines is the

View solution

Q. Schedule number of a pipe, which is a measure of its wall thickness, is given by

View solution

Q. The net positive suction head (NPSH) of a centrifugal pump is defined as the sum of the velocity head and the pressure head at the

View solution

Q. For a particle settling in water at its terminal settling velocity, which of the following is true ?

View solution

Q. A Bingham fluid of viscosity μ = 10 Pa.s and yield stress, τ₀ = 10 KPa, is shared between flat parallel plates separated by a distance of 10⁻³ m. The top plate is moving with a velocity of 1 m/s. The shear stress on the plate is

View solution

Q. Pick out the correct statement.

View solution

Q. Shear stress in a fluid flowing in a round pipe

View solution

Q. The resistance wire used in a hot wire anemometer for conducting electrical current is made of

View solution

Q. The ratio of the hydraulic radius to the diameter of the channel, for maximum mean velocity of flow in a circular channel, in open channel flow is

View solution

Q. For the free settling of a spherical particle through a fluid, the slope of, Cᴅ-log Nʀₑ , plot is

View solution

Q. A centrifugal pump loses prime after starting. The reason of this trouble may be

View solution

Q. Venturimeter and orificemeter measures the __________ of the fluid.

View solution

Q. Surge tanks are provided in high pressure water pipelines to

View solution

Q. Capacity of a hydraulic accumulator is defined in terms of maximum

View solution

Q. With diminishing cross-sectional area in case of subsonic flow in a converging nozzle, the

View solution

Q. Boundary layer separation is characterised by one of the conditions given below, where 'Re' is the Reynolds number for the flow. Select the appropriate conditions.

View solution