Q. Centre of pressure in an immersed body is __________ the centre of gravity.

View solution

Q. The centre of pressure is

View solution

Q. The uniformity of a gas fluidised bed depends upon the __________ of the solid particles.

View solution

Q. A differential pressure cell is used for

View solution

Q. If more than two branches of pipes are to be connected at the same point, then use a/an

View solution

Q. In case of a centrifugal pump, the ratio of total delivered pressure to pressure developed with the impeller is called the __________ efficiency.

View solution

Q. Pick out the wrong statement.

View solution

Q. Mass velocity is independent of temperature & pressure, when the flow is

View solution

Q. Very small pressure difference (< 5 mm water coloumn) can be most conveniently measured by a/an __________ manometer.

View solution

Q. For pipe flows, head is proportional to __________ at constant capacity(where, D = pipe diameter).

View solution

Q. For a given Reynold number as d/D for an orifice increases, Cd will (where, d & D are orifice & pipe diameters respectively).

View solution

Q. The ratio of wall drag to total drag in the Stoke's law range is

View solution

Q. Rotary vacuum pumps can reduce the absolute pressure to as low as __________ mm Hg.

View solution

Q. A pitched-blade turbine draws __________ a straight blade turbine.

View solution

Q. The most suitable flow measuring device for the fluid flow measurement in a very large diameter pipeline is a

View solution

Q. A centrifugal pump is called a turbine pump, if it is having a

View solution

Q. Acceleration head in a reciprocating pump

View solution

Q. The ratio of inertial forces to elastic forces is called the __________ number.

View solution

Q. Fluid flow at increasing rate through a diverging pipe is an example of __________ flow.

View solution

Q. The temperature in isentropic flow

View solution