Q. Pick out the correct statement pertaining to transition/ entrance length in fluid flow.

View solution

Q. A perfect gas

View solution

Q. Which of the following is the most common pump for pumping either raw sewage or sludge ?

View solution

Q. Transition length for a turbulent fluid entering into a pipe is around __________ times the pipe diameter.

View solution

Q. For turbulent flow of an incompressible fluid through a pipe, the flow rate Q is proportional to (Δ P)n, where ΔP is the pressure drop. The value of exponent 'n' is

View solution

Q. Reciprocating pumps are not able to compete with the centrifugal pump for industrial use, mainly because these pumps have

View solution

Q. The ratio of hydrodynamic boundary layer to thermal boundary layer thickness in case of liquid metals is

View solution

Q. The general relationship between speed N, head H, power P and discharge Q for a centrifugal pump is

View solution

Q. What is the ratio of the velocity at the axis of the pipe to the mean velocity of flow in case of pipe flow under viscous condition ?

View solution

Q. Foot valve provided in the pump is a __________ valve.

View solution

Q. The discharge co-efficient for an orificemeter does not depend upon the

View solution

Q. If the head over the triangular notch is doubled, the discharge will increase by __________ times.

View solution

Q. Friction factor for a hydraulically smooth pipe at Nʀₑ = 2100 is f₁. If the pipe is further smoothened (i.e., roughness is reduced), the friction factor at the same value of Nʀₑ, will

View solution

Q. For the laminar flow of a fluid in a circular pipe of radius R, the Hagen-Poisseule equation predicts the volumetric flow rate to be proportional to

View solution

Q. Interstage coolers are provided in a multistage compressor to

View solution

Q. The ratio of the wall drag to the form drag in the Stoke's law range (for motion of spherical particles in a stationary fluid) is

View solution

Q. For turbulent flow in smooth circular pipe, the velocity distribution is a function of the distance 'd' measured from the wall of the pipe and the friction velocity 'v', and it follows a __________ relationship.

View solution

Q. Maintenance cost of a __________ pump for a particular duty is the least.

View solution

Q. Choking in case of pipe flow means that a

View solution

Q. Velocity of liquid hydrocarbon fuels in a pipeline can not be measured by magnetic flowmeters, because their __________ is very low/small.

View solution