Q. For a fluid rotating at constant angular velocity about vertical axis as a rigid body, the pressure intensity varies as the

View solution

Q. In a dry packed bed, the pressure drop will be changed by increasing the flow rate as

View solution

Q. Specific speed of a centrifugal pump depends upon the __________ head.

View solution

Q. Navier-Stokes equation is useful in the analysis of __________ fluid flow problems.

View solution

Q. With increase in molecular weight of the gas, the head developed by a centrifugal compressor will

View solution

Q. Pressure difference between two points in vessels, pipelines or in two different pipelines can be measured by a differential manometer. The pressure difference measured as the mm of water coloumn in case of mercury-water, differential manometer is equal to (where, H = difference in height of mercury column in mm).

View solution

Q. The boundary layer thickness at a given section along a flat plate __________ with increasing Reynold's number.

View solution

Q. Low specific speed of a pump implies that, it is a/an __________ pump.

View solution

Q. The maximum discharge through a circular channel takes place, when the depth of the fluid flow is __________ times the pipe diameter.

View solution

Q. When the head pumped against is less than the head of the fluid used for pumping, the usual device is a/an

View solution

Q. Two fluids are flowing through two similar pipes of the same diameter. The Reynold's number is same. For the same flow rate if the viscosity of a fluid is reduced to half the value of the first fluid, the pressure drop will

View solution

Q. What is the value of co-efficient of discharge for square edged circular orifice (for β = 0.3 to 0.5) ?

View solution

Q. A lubricant 100 times more viscous than water would have a viscosity (in Pa.s)

View solution

Q. Nominal Pipe Size (NPS) of a pipe less than 12 inches in diameter indicates its

View solution

Q. I.D. of 1/4" schedule 40 pipe is 0.364". I.D. of a 1/2" schedule 40 pipe would be __________ inch

View solution

Q. A pump operating under specific conditions delivers insufficient quantity of liquid. This may be set right by

View solution

Q. Two liquids manometer is used for measuring small pressure differences in

View solution

Q. A piezometer provided in the pipe measures

View solution

Q. For pumping slurry, one can use a __________ pump.

View solution

Q. Bernoulli's equation describes the

View solution