Question
a.
that corresponding to static bed.
b.
that corresponding to completely fluidised bed.
c.
the porosity of the bed when true fluidisation begins.
d.
less than that of the static bed.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Minimum porosity for fluidisation is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A centrifugal pump used to pump water is used to pump an oil with specific gravity of 0.8 at the same rate. The power consumption will now
View solution
Q. Steady non-uniform flow is exemplified by flow through a/an
View solution
Q. The maximum depth from which a centrifugal pump can draw water is
View solution
Q. Design of the casing of centrifugal pump should be such as to minimise the
View solution
Q. Which of the following is used for pumping crude oil from oil well ?
View solution
Q. The energy loss in flow through ven-turimeter is less than that through flow nozzle, because in case of a flow nozzle, the
View solution
Q. __________ flow means the flow of incompressible fluid with no shear.
View solution
Q. A centrifugal pump has the following specifications:
Power = 4 H.P.
Speed = 800 rpm
Head = 8 metres
Flow = 1000 litres/minutes.
If its speed is halved, the power consumed now will be __________ hp.
View solution
Q. Transition length for turbulent flow in smooth pipe is equal to __________ times the pipe diameter.
View solution
Q. Disc compensators are provided in large diameter fuel gas carrying pipelines to
View solution
Q. Discharge from a 24 inch pipe of water at 10 ft/sec will be __________ ft³/sec.
View solution
Q. Paper pulp is an example of __________ fluid.
View solution
Q. __________ is an example of axial flow impeller.
View solution
Q. Froude number is not a factor
View solution
Q. If three pipes of different diameters, lengths & friction factors are connected in parallel, then (where, Q = flow rate, V= fluid velocity f = friction factor).
View solution
Q. Horsepower requirement for given pump capacity depends upon the
View solution
Q. Bernoulli's equation accounts for the
View solution
Q. Hot wire anemometer is used to measure the
View solution
Q. Propeller type centrifugal pumps are most suitable for
View solution
Q. The fluid velocity varies as the square of the cylindrical pipe diameter, in case of steady state laminar flow at constant pressure drop, for __________ fluid.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
