Q. A fluid is pumped at the rate of 10 lb/sec to a height of 55 ft. The horse power required is __________ hp.

View solution

Q. With increase in pump speed, its NPSH requirement

View solution

Q. In the Newton's law range, the terminal velocity of a solid spherical particle falling through a stationary fluid mass is __________ the fluid viscosity.

View solution

Q. Gear pump

View solution

Q. Most of the centrifugal pumps used in chemical plants are usually __________ driven.

View solution

Q. Check valve provided in the discharge line of a centrifugal pump serves the purpose of controlling the

View solution

Q. Which of the following two quantities when same, makes one pipe system equivalent to another pipe system ?

View solution

Q. The kinetic energy correction factor for velocity distribution of laminar flow is

View solution

Q. Priming of a centrifugal pump is done to

View solution

Q. Bed pressure drop in an air fluidised bed of catalyst particles (ρₚ = 200 kg/m³, Dₚ = 0.05 cm) of 60 cm bed depth and bed porosity of 0.5 expressed in cm of water (manometer) is

View solution

Q. For pipes that must be broken at intervals for maintenance, the connector used should be a/an

View solution

Q. Absolute viscosity of a fluid is a function of the __________ of the fluid.

View solution

Q. Select the wrong statement pertaining to flow of an incompressible fluid through a venturimeter.

View solution

Q. Reynolds number for water flow through a tube of I.D. 5 cm is 1500. If a liquid of 5 centipoise viscosity and 0.8 specific gravity flows in the same pipe at the same velocity, then the pressure drop will

View solution

Q. The bulk modulus of elasticity of a liquid

View solution

Q. Potential flow is the flow of

View solution

Q. The value of critical Reynolds number for pipe flow is

View solution

Q. Mach number is important in a fluid flow problem, when the inertia and __________ forces predominate.

View solution

Q. Fanning friction factor is equal to (where, fʙ = Blassius friction factor).

View solution

Q. In case of coutte flow, the fluid flow is between two large flat parallel plates with

View solution