Q. Flow rate of high velocity flue gas discharged through a stack to the atmosphere can be most conveniently measured by a

View solution

Q. What is the ratio of total kinetic energy of fluid passing per second to the value obtained on the basis of average velocity (for laminar flow through a circular pipe)?

View solution

Q. The line traced by a single fluid particle as it moves over a period of time is called __________ line.

View solution

Q. The pressure head on sudden contraction in a horizontal pipe is converted into the __________ head.

View solution

Q. A stream tube is that, which has __________ cross-section entirely bounded by stream lines.

View solution

Q. A mixed flow centrifugal pump

View solution

Q. In centrifugal pump operation, the cavitation can be eliminated by maintaining suction pressure __________ the vapor pressure of the liquid at the suction temperature.

View solution

Q. A rectangular surface 3' x 4', has the lower 3 edge horizontal and 6' below a free oil surface (sp. gr. 0.8). The surface inclination is 300 with the horizontal. The force on one side of the surface is (where, y = specific weight of water)

View solution

Q. A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun's equation for the above fluid-particle system (in SI units) is given below :

Δ P/L = 375 x 10³ Vₒₘ + 10.94 x 10⁶ V² ₒₘ (SI units)

If water is to be used as the fluidising medium, the minimum fluidisation velocity, Vₒₘ is

View solution

Q. One dimensional flow implies

View solution

Q. The unit of velocity head is

View solution

Q. Which of the following properties of a fluid is responsible for offering resistance to shear ?

View solution

Q. Erosion and pits formation on the impeller of a centrifugal pump may be due to

View solution

Q. The velocity profile exhibited by laminar flow of Newtonion fluids is such that the velocity distribution w.r.t. radius of the circular pipe is a/an __________ with the apex at the centre line of the pipe.

View solution

Q. The blades of a centrifugal impeller are said to be curved forward, if the __________ of the motion of impeller blades.

View solution

Q. For the same terminal conditions and fitting size, the least friction loss is incurred in a/an

View solution

Q. A floating/submerged body is always stable, if its centre of gravity

View solution

Q. The co-efficient of discharge of an orificemeter is a function of

View solution

Q. Critical velocity in a pipe flow

View solution

Q. Which of the following conditions must be satisfied for lift force to be developed ?

View solution