Q. Energy consumed for crushing one ton of material ranges from __________ kWh.

View solution

Q. For transporting pasty material, one will use a/an

View solution

Q. Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a

View solution

Q. A tube mill compared to a ball mill

View solution

Q. Trommels separate a mixture of particles depending on their

View solution

Q. Size reduction does not occur due to compression in case of

View solution

Q. According to Taggart's rule for selecting between a gyratory crusher and a jaw crusher; the later should be used, if the hourly tonnage to be crushed divided by the square of the gape expressed in cm is less than

View solution

Q. Which of the following represents the plot of filtrate volume versus time for constant pressure filtration ?

View solution

Q. Driving force in case of filtration by a centrifuge is the

View solution

Q. Rod mills employed for grinding

View solution

Q. A widely used size reduction equipment for __________ is Bradford breaker.

View solution

Q. Ultra centrifuges are used for the separation of __________ solid particles.

View solution

Q. Specific surface area is the surface area of a unit __________ of materials.

View solution

Q. A. __________ mill is a revolving mill divided into two or more sections by perforated partitions in which preliminary grinding takes place at one end and the finishing grinding at the discharge end.

View solution

Q. The constants (Kb, Kr and Kk) used in the laws of crushing (i.e., Bond's law, Rittinger's law and Kick's law) depend upon the

View solution

Q. __________ balls capable of grinding the feed in a ball mill gives the maximum efficiency.

View solution

Q. The speed of a rotary drum vacuum filter may be about __________ rpm.

View solution

Q. Colloid mills achieve size reduction mainly by

View solution

Q. Mesh indicates the number of holes per

View solution

Q. For achieving maximum capacity of the ball mill, the ball charge should be equal to about __________ percent of the ball mill volume.

View solution