Question
a.
secondary
b.
fine
c.
primary
d.
ultrafine
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the __________ crushing.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. As per Taggart's formula, the capacity (kg/hr) of Jaw & Gyratory crushers (for gapes of 10 to 60 cms) is equal to (where, L = Length of feed opening, cms S = Maximum width of discharge opening, cms )
View solution
Q. The process by which fine solids is removed from liquids is termed as
View solution
Q. Which of the following crushing laws is most accurately applicable to the fine grinding of materials ?
View solution
Q. Shell and leaf filter as compared to plate and frame filter
View solution
Q. Pick out the wrong statement.
View solution
Q. Which of the following oxides is not present in hematite iron ore?
View solution
Q. Ribbon blenders are exclusively meant for
View solution
Q. In closed circuit grinding as compared to open circuit grinding, the
View solution
Q. Pick out the correct statement.
View solution
Q. Separation of solid particles based on their densities is called
View solution
Q. Activators are those chemicals which help buoying up one mineral in preference to the other in the froth floatation process. Which of the following is an activator?
View solution
Q. __________ are mixed using ribbon blenders.
View solution
Q. During agitation of liquids, the
View solution
Q. For crushing of solids, the Rittinger's law states that the work required for crushing is proportional to
View solution
Q. Traces of liquid tar fog present in coke oven gas is separated using
View solution
Q. Close circuit grinding by a ball mill with air sweeping employs a
View solution
Q. Work index is the gross energy (kWh/tonne of feed) necessary to reduce a very large feed to such a size that 80% of product particles will pass through a 0.1 mm screen. The value of work index determined for wet grinding should be multiplied with __________ to get the same for dry grinding.
View solution
Q. Choke crushing (in case of a Jaw crusher) compared to free crushing
View solution
Q. The specific surface of sherical particles is proportional to (where, Dₚ = diameter of particle).
View solution
Q. Wheat is ground into flour in a
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
