Q. Thermodynamic celcius scale of temperature measurement is

View solution

Q. According to Bode stability criterian, a system is unstable, if the open loop frequency response exhibits an amplitude ratio exceeding unity at frequency for which phase lag is

View solution

Q. In a closed loop system, the process to be controlled is an integrating process with transfer function 1/2s. The controller proposed to be used in an integral controller with transfer function 1/T₁s. When a step change in set point is applied to such a closed loop system, the controlled variable will exhibit

View solution

Q. Flow rate of those fluids which are insensitive to changes in their density, viscosity or flow velocity profile can be best measured by a

View solution

Q. Identify an unbounded input from inputs whose transfer functions are given below

View solution

Q. "A control system is unstable, if the open loop frequency response exhibits an amplitude ratio exceeding unity at the crossover frequency." This is __________ criterion.

View solution

Q. Feed forward controller accounts for the __________ changes.

View solution

Q. Which thermocouple can be used to measure a temperature of around 1400°C ?

View solution

Q. Radiation pyrometers as compared to thermocouples

View solution

Q. Liquid flow rate in a small channel is best measured by a/an

View solution

Q. Specific gravity of a liquid can not be measured by a/an

View solution

Q. __________ temperature scale assigns 0° to the 'ice point' and 80° to the 'steam point'.

View solution

Q. Dead zone is the

View solution

Q. Thermocouple in a thermal well behaves as a true

View solution

Q. Bode diagram is a plot of

View solution

Q. Working principle of disappearing filament type optical pyrometer is based on the

View solution

Q. Strain gage uses an electrical conductor wire, which when elastically stretched increases in length and reduces in diameter. Both these dimensional changes result in __________ in the electrical resistance of the wire.

View solution

Q. Measurement of sub-zero Celcius temperature in industry is done most commonly by

View solution

Q. Use of I-control along with P-control facilitates

View solution

Q. Turbine flow meters are suitable for

View solution