Q. The open loop transfer function of a control system is KR / (1+TS) . This represents

View solution

Q. Thermal conductivity measurement is used for the determination of

View solution

Q. Presence of a small amount of water in the organic systems can be determined by the __________ method.

View solution

Q. Thermal wells used in temperature measurements should have

View solution

Q. Which of the following flow-metering instru-ments is an areameter ?

View solution

Q. Out of the following themocouple wire insulating material, the highest temperature rating is for

View solution

Q. Which is the most suitable instrument for measuring pressure below 3 microns ?

View solution

Q. Routh stability method uses __________ loop transfer function.

View solution

Q. Liquid levels in autocalves are measued by

View solution

Q. E.m.f. generated by thermocouples is of the order of

View solution

Q. A pyrheliometer is an instrument used for measuring the

View solution

Q. Flow rate through an orifice is __________ the pressure differential.

View solution

Q. Flow rate of sludge is not measured by a/an

View solution

Q. In a shell and tube heat exchanger, the inlet temperature of heating/cooling fluid is the __________ variable.

View solution

Q. Polarisation of light forms the working principle of a

View solution

Q. A bimetallic thermometer as compared to industrial mercury in glass thermometer has almost the same

View solution

Q. Time constant is the

View solution

Q. Mercury manometer (U-tube type) exemplifies a __________ order system.

View solution

Q. Emf developed by a thermocouple while measuring a temperature of 400°C is 22 mV. The type of thermocouple used is

View solution

Q. Bode stability method uses __________ loop transfer function.

View solution