Q. When an exothermic reversible reaction is conducted adiabatically, the rate of reaction

View solution

Q. For a first order chemical reaction in a porous catalyst, the Thiele modulus is 10. The effectiveness factor is approximately equal to

View solution

Q. In solid catalysed reactions the diffusional effects are more likely to affect the overall rate of reaction for

View solution

Q. Helium-mercury method can be used to determine the __________ of the catalyst particle.

View solution

Q. For the chemical reaction X → Y, it is observed that, on doubling the concentration of 'X', the reaction rate quadruples. If the reaction rate is proportional to Cₓⁿ, then what is the value of 'n' ?

View solution

Q. Chemical reaction rate of a component depends upon the

View solution

Q. In a semi-batch reactor

View solution

Q. The equilibrium constant K of a chemical reaction depends on

View solution

Q. The reaction rate almost gets doubled for 10°C rise in temperature. This is due to the fact that the

View solution

Q. Which of the following is not a unit of reaction rate ?

View solution

Q. Brunaur, Emmet and Teller (BET) equation is used to determine the specific surface area of a porous particle but not the pore volume & the porosity of the catalyst bed. Which of the following postulates is not used to derive BET equation ?

View solution

Q. The sequence in which three CSTR's of volumes 5, 10 and 15 m³ will be connected in series to obtain the maximum production in a second order irreversible reaction is

View solution

Q. With increase in temperature, the equilibrium conversion of a reversible exothermic reaction

View solution

Q. In a CSTR __________ varies with time.

View solution

Q. The following gas phase reactions are carried out isothermally in a CSTR.

A → 2R ; r₁ = k₁pᴀ ;
k₁ = 20 mole/(sec.m³ bar)
A → 3S ; r₂ = k₂ pᴀ ;
k₂ = 40 mole/(sec.m³ .bar)

What is the maximum possible value of Fʀ(mole/sec.) ?

View solution

Q. As the chemical reaction proceeds, the rate of reaction

View solution

Q. Pick out the wrong statement.

View solution

Q. For identical flow rate and feed composition, X plug flow reactors (PER) in series with a total volume V gives the same conversion as single

View solution

Q. Time required for 50% decomposition of a liquid in an isothermal batch reactor following first order kinetics is 2 minutes. The time required for 75% decomposition will be about __________ minutes.

View solution

Q. For a __________ order reaction, the units of rate constant and rate of reaction are the same.

View solution